STANDARD ALIGNMENT

The Standard for Alignment was developed by Antares to facilitate further the process of assembling and adjusting elastic center. This is a simple and original with which there is the alignment of the equipment, in axial and radial direction. It extremamante light and handy, being manufactured in 9 sizes. Can be used in all conventional couplings Antares with cubes and cubes Normal Integrals and some special versions.

 

RUBBER PARTS - SEAL INDUSTRIAL

How to properly store your rubber parts

The temperature should not exceed 50 ° C.
For added durability, seek to exclude the air (oxygen).

Browse away generating elements of particulate matter (dust).

Removing direct incidence of light (especially ultraviolet).

Main functions of the loads on tape-guides

FIBERGLASS
High compressive strength
Wear resistance
Very good chemical resistance
CARBON
Wear resistance
High compressive strength
Good thermal conductivity
GRAPHITE
Good thermal conductivity
Good sliding properties
Low coefficient of friction
BRONZE
Wear resistance
High compressive strength
Low flow cold
excellent thermal conductivity
MoS²
Excellent sliding properties
Reduces wear

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

RETAINERS

Mounting and application

• Only remove the retainer package in time to apply it;
• Never leave the retainer in the toolbox along with other pieces;
• Never leave the retainer hung on nails;
• Lubricate the oil seal lip before mount it (you can use your own fluid application);
• Never reuse the retainer in place of the old runway and never use or do reapertos spring;
• Never sand the shaft (will create microscopic channels.) Remember that the surface should always be free of beats, grooves, cracks, deformations or oxidations.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

Gauges

Operating temperature of gauges usually
Low of -10 ° C and maximum 65 ° C for ambient and process fluid.

Operating temperature above 65 º C
It is recommended to install pipe - siphon, coil or diaphragm seal, in processes with temperatures above 65 º C, to protect and reduce the temperature at the measurement site.
Applied in steam lines or liquid whose temperature exceeds the temperature limit of operation of the instrument.

Diaphragm Seals
Serve to separate and protect the instrument's measuring process.
Isolating the gauge of the possible products: corrosive, viscous, solid particles, freezing, food products, and other excessive temperatures.

Shock Pulse
They serve to eliminate or lessen the effects of pulsating pressure line, avoiding decalibration or system wear.

Pressure gauges with glycerine filling
Applied in industries in general, in places with high vibrations, pressure surges, or pulse line, thereby increasing the life of the gauge.

Valves for Gauges
Valves record for manometers serve to isolate the process instrument or dampen and attenuate the pulsation of the line and also allows removal without the need to halt the process.

Pressure scale
Generally the selected pressure range is twice the operating pressure.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

THERMOMETERS

Thermowells
Act as mechanical protection, isolating the process fluid from the sensing rod and the instrument also allows removal without the need to halt the process.





PROTEC - Parts for Industrial Maintenance
CNPJ: 02.073.130-0001/80